Aspire Zelos 3 Kit

Aspire Zelos 3 Kit

The Zelos 3 Kit was created from the Zelos 3 Mod and the Nautilus 3 atomizer to create a powerful and classy Vape kit with an excellent draw.

Zelos 3 Mod

Sleek and handy, the Zelos 3 Mod is made from the zinc and aluminum alloy. On its 510 connector can be easily screwed atomizers with a diameter up to 26 mm. Inside the Zelos 3 Mod is a3200 mAh strong Accu permanently installed. Thus, a peak power of up to 80 watts can be achieved. Charging is done via the USB Type-C port with 2A. Thus, the Zelos 3 Mod is fully operational again in about 90 minutes. On the 0.96" TFT display, all information is presented very clearly. Using the fire button and the two control buttons, not only can the power be adjusted, but the color of the display can also be customized. Further, the Zelos 3 Mod offers the possibility to be used in different modes. Aspire has missed in a watt mode, a volt mode, the Bypass mode and the TC mode with SS316, Ni, Ti, the TCR mode and the CPS mode. Thus, the Zelos 3 Mod can be used very versatile. Aspire has also packed a lot into the Zelos 3 battery mod in terms of safety, but it offers short-circuit protection, a draw time limit, overheating protection, low-voltage protection as well as deep discharge protection to provide a safe vapor experience.

Nautilus 3 atomizer

The Kit is rounded off by the Nautilus 3 atomizer, this is made from the best Stainless steel and a Pyrex Glass. With its diameter of 24 mm, it fits perfectly with the Zelos 3 Kit. The filling volume of the elegant Nautilus 3 atomizer is 4 ml. It is filled from the top via the slide-on Top Cap with a replaceable 510 Drip Tip. Via the adjustable Bottom Airflow, the draw behavior can be adjusted entirely to personal needs. Aspire has provided the Nautilus 3 with 7 air holes ranging from 0.8 mm to 3 mm. This allows the draw resistance to be adjusted from classic MTL to restrictive DL. To achieve this draw behavior, the Nautilus BVC Coil or Nautilus 2S Coils are used. These can be inserted into the atomizer from below. Included in delivery is already a 0.7 Ohm Nautilus 2 S Mesh Coil, this is for a power of 20 to 25 watts and a restrictive DL draw behavior. Further, a 1.8 Ohm BVC Coil for 10 to 14 watts and a classic MTL draw behavior is already there. It can also use all other coils from the Nautilus 2 and 2 S Coil series, as well as all coils from the BVC series.