PAX 3 Vaporizer - Basic Kit

Pax 3 Vaporizer Base Kit

The Housing of the Pax 3 Vaporizer is made of aluminum and polished to a high shine. With a handy size of 98.5 mm x 30.6 mm x 21.4 mm, you can easily carry it with you and enjoy a vape session on the go.

The Pax 3 is a true powerhouse, inside is a permanently installed Accu with an impressive capacity of 3500 mAh. The scope of delivery also includes a charger, with which you can recharge the Pax 3 and per battery charge to ten vape sessions are possible. On the Housing are LEDs in petal shape, which keep you informed about the battery status: 1 white petal = 0 to 25%, 2 white petals = 25 to 50%, 3 white petals = 50 to 75% and 4 white petals = 75 to 100%. The special thing about the Pax 3 is that it has a motion sensor, so as soon as you shake the device, it shows you the battery level.

The PAX 3 is switched on by briefly pressing the Mouthpiece and to enter the temperature mode, you press the Mouthpiece longer, after which you can switch between the four temperature modes with short clicks on the Mouthpiece. The petal LED display informs you about the selected temperature mode: 1 green petal = 182 °C, 2 yellow petals = 193 °C, 3 orange petals = 205 °C and 4 red petals = 215 °C. The selected mode is confirmed by pressing the Mouthpiece. Confirm the selected mode by pressing and holding the Mouthpiece. After that, the device goes into heating mode and the heating time is just phenomenal 10 to 15 seconds. In addition, you have the option of downloading the app from PAX in the Google Playstore on your smartphone, with which you get full control over the entire temperature range between 174 °C and 215 °C. Another highlight of the PAX 3 is that it is equipped with a unique lip sensor, through it it recognizes when it needs to heat and when it can turn off the heating, which makes the device stand out for its sophisticated energy efficiency.

If you want to use the Pax 3 with herbs, then you either fill the Heating chamber completely with herbs or you also have the option to fill the Heating chamber only up to half with herbs. If you fill it halfway, you use the heating chamber cover with a recess, and if you fill it full, you keep the standard cover. However, if you prefer to use concentrates, take the concentrate cover and open the container. Place the concentrate on the bottom of the container between the two air inlets and then close the container and insert the concentrate cover into the unit. Please note that the base kit does not include a concentrate insert in the Scope of delivery, this can be ordered separately and can be found in the accessories .